HaysStanford Posted December 14, 2012 Share Posted December 14, 2012 Does anyone have any ideas or techniques they use to make their skimmer remove as many proteins as it possibly can? Quote Link to comment Share on other sites More sharing options...
Juiceman Posted December 14, 2012 Share Posted December 14, 2012 Quote Link to comment Share on other sites More sharing options...
+brian.srock Posted December 14, 2012 Share Posted December 14, 2012 Throwing an airstone in there will help with making micro bubbles and you can throw it on a gang valve to control the air flow. Quote Link to comment Share on other sites More sharing options...
HaysStanford Posted December 14, 2012 Author Share Posted December 14, 2012 Great video! Thanks for the info Quote Link to comment Share on other sites More sharing options...
bimmerzs Posted December 18, 2012 Share Posted December 18, 2012 Wet skimmate is the thin light green tea-colored solution collected when lots of air and a relatively high water column height is adjusted for in skimmers that are adjustable (MR-2 type skimmers). This removes a lot of seawater and requires that any auto-top-off devices be turned off during such operations. Failure to do so may result in dilution of salinity. As an alternative (especially in sumpless systems), the system may be overfilled with seawater and skimmed down to normal levels.Dry skimmate is the thick, concentrated skimmate collected when water column height is adjusted to about 3 or 5 cm below the collection neck (may be more or less depending on pump, skimmer brand, and venturi/air injection device) and the air injection is reduced to prevent excessive foam formation. This allows the skimmate to concentrate in the foam formed within the collection riser so that the skimmate collected in the cup is quite concentrated, relatively "drier" than the thin wet skimmate collected with less restrictive adjustments. This is usually the optimum setting for skimmers, as it does not remove large volumes of water while the system is unattended, yet effectively removes large amounts of DOC and particulates from the water column. This conservation of seawater helps to prevent fluctuations in salinity, especially in systems with automatic top off devices in operation.Wet skimmate allows for better rapid collection of particulates and some organics, but at the cost of collecting extra water (around 2 to 3 gallons every 30 minutes to an hour, depending on the adjustment settings.) This extra water collected can be added to the total for discard from water changes, and acts to clear the water column of suspended detritus. This is especially helpful while performing detritus siphoning/uspension and algal scraping of the glass and when blowing the rock with current to remove detritus. You'll need to keep track of the total amount of seawater removed from the system, and replace that amount with fresh seawater to maintain salinity parameters. If you use auto-top off, make sure to adjust the height of the water in the sump before restarting the auto-top-off to prevent changes in your system's salinityThe quick and dirty on skimmate, hope this helps. Here's a bit more informtion from an online poster concerning the two methods of skimming. I usually prefer to dry skim however, I find that sometimes wet skimming is necessry depending on what I'm doing with my tank. Above quotes taken from this link. http://www.thereeftank.com/forums/f6/wet-skimming-vs-dry-skimming-49194.html Cheers, Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.